The TPV6823 is a supervisory circuit that monitors power supply voltage levels and provides a power-on reset signal.

BL8506 is a series of high precision voltage detector with ultra-low current consumption (500nA typ. at VDD=3.0V). It can work at very low voltage, which makes it perfect for system reset.

BLL2770 is a 40V synchronous constant current buck LED driver, with 55mΩ High-Side and 20mΩ Low-Side MOSFETs integrated, minimal external component requirement and high efficiency, ideal for car lamp applications.

The BL5612 is one channel H-Bridge driver IC, it provides integrated motor-driver solution for toys, robotics, consumer products and other low voltage or battery-powered motion control applications.

The TPM2003 is a high-voltage, high-current NMOS transistor array. This device consists of seven channels of low-side NMOS transistors with high-voltage outputs and free-wheeling diodes for inductive loads. The maximum drain-current rating of a single NMOS channel is 500 mA. The device supports a wide I/O voltage range from 1.8 V to 30 V. The transistors can drive in parallel for higher current capability. Enhanced ESD performance enhances system-level reliability. The TPM2003 can replace traditional Bipolar Darlington arrays with better thermal efficiency and reliability.

BL8851 combines a dedicated current mode PWM controller. It is optimized for high performance, low standby power, and cost effective off- line fly back converter applications in 40W~60W range.

The TPL820 is a series of high-performance and low-dropout linear regulators. The TPL820 series supports a maximum 42-V input voltage and a 180-mA output current with low quiescent current and high PSRR. The TPL820series is stable with a 2.2-μF to 22-μF output capacitor，and a 4.7-μF ceramic capacitor is recommended.

BL1117 is a series of low dropout three-termina! regulators with a dropout of 1.3V at 1A load current. BL1117 features a very low standby current 2mA compared to 5mA of competitor.

BL8531 series are CMOS-based PFM step-up DCDC Converter. The converter can start up by supply voltage as low as 0.8V, and capable of delivering maximum 200mA output current at 3.3V output with 1.8V input Voltage. Quiescent current drawn from power source is as low as 5.5uA. All of these features make BL8531 series be suitable for the portable devices, which are supplied by a single battery to four-cell batteries.

The BL9366 is a monolithic, step-down, switch mode converter with a built-in power MOSFET. It achieves a 0.6A peak-output current over input supply 5.0V-60V with excellent load and line regulation. Current-mode operation provides a fast transient response and eases loop stabilization. Fault condition protections include cycle-by-cycle current limiting and thermal shutdown.